Tektronix TLA5202

Table of Contents
ii
TLA5000 Series Service Manual
Probe Interface 3--3..................................................
Acquisition 3-- 3.....................................................
Internal Indicator LEDs 3--4...........................................
Performance Verification
Summary Veri ficat ion 4--1.............................................
Test Equipment 4--3..................................................
Test Equipment Setup 4--3............................................
Connecting the Test Fixture 4--4....................................
Installing the Performance Verification and Adjustment Software 4-- 4......
Starting the Performance Verification Software 4-- 5.....................
Software Ove rview 4--6...........................................
Obtaining Test Results 4-- 6.........................................
Troubleshooting 4--6..............................................
Functional Verification 4-- 7............................................
Test Equipment 4--7..............................................
Setup 4--7......................................................
Self Tests and Power-On Diagnostics 4--7.............................
Extended Diagnostics 4--8.........................................
Mainframe Diagnostics 4--8........................................
Probe Functional Verification 4--9...................................
Performance Verification Instructions 4--9................................
Prerequisites 4--9................................................
Procedure Overview 4--9..........................................
Performance Verification Procedures 4--11................................
Module+Probe Gain & Offset Procedures 4--13.........................
Module+Probe Timing Procedures 4-- 15...............................
Setup and Hold Procedure 4--17......................................
Logic Analyzer Certification 4-- 19.......................................
Equipment Setups 4--19............................................
Start the Software 4--20............................................
Adjustment Procedures
Test Equipment and Initial Setup 5-- 1....................................
Prerequisites 5--1....................................................
Using the Software 5--2...............................................
Performing the Adjustments 5-- 2....................................
Adjustment After Repair 5-- 2.......................................
Test s Performed 5--2.................................................
Self Calibration 5-- 3.............................................
Module+Probe Timing Procedures 5--5...................................
Equipment Setups 5--5............................................
Start the Software 5--5............................................
Completing the Adjustment Steps 5-- 8...................................