29
GETTING STARTED
1. The unit requires 3 X 1.5V AA batteries. Open the battery
compartment cover and insert the batteries in the right polarity, then
close the cover (Proposal using alkaline battery). There should be
time display on the liquid crystal screen after the batteries are
inserted.
2. Insert one end of the line cord to the line jack of the base and the
other end to the wall outlet of exchange.
3. Connect the handset and the unit with coiled line.
4. Setting the dialing mode to correct mode according to the directions
from your local telecom.
5. Apply for the caller ID from your local telecom office.
RECEIVING A CALL
1. When a call comes, the telephone rings, the NEW LED flickers and
LCD displays the seq. number of the call, the date, time, and the
NEW icon.
2. For the repeated incoming call, the LCD displays REPEAT icon.
3. If there is missed call has not been reviewed, the NEW LED will
flash interval several seconds.
4. When the incoming memory is full, the latest incoming number
replaces the oldest number in the memory.
Note: For the phone to display incoming number and other information,
you must have an active Caller ID subscription with your local telephone
exchange company.
To Next Page
