Telco GCE6215 - Secret Code Setting and Remote Monitor Function

35
3. If choose “-”, it means no PABX code has been set.
4. Press SET key to confirm and exit.
Setting Alarm Clock
1. In on-hook state, press ALARM/P key once, LCD displays
12-00AL1,
2. Press UP/+ or DOWN/– key to select ON or OFF. LCD displays
“ALM” icon when the alarm is set to ON.
3. Press SET key, value “12” starts to flash.
4. Press UP/+ or DOWN/– key to set the alarm hour and press SET
key to confirm and enter alarm minute setting.
5. Press UP/+ or DOWN/– key to edit alarm minute and press SET
key to confirm and go to next group alarm clock setting.
6. Repeat the above steps to set additional alarms.
Note: The first 3 groups alarm clock setting will be repeated
periodically every day while the last 2 groups alarm clock setting are
affected once.
SECRET CODE SETTING AND REMOTE MONITOR FUNCTION
Setting
1. Set the ringer to OFF. (Please refer to section “SETTING
RINGING TONE AND ADJUST RINGING VOLUME”).
2. In on-hook state, press and hold HD/RING key for 3 seconds,
LCD displays Pin ----.
3. Input a 4-digit of PIN using the numeric keys or press DEL to delete.
4. Press SET to confirm.