40
Make a call from two-touch memory
In off-hook or hands-free state, press MEMORY + numeric key (0-9), the
relevant number will be dialed out.
LCD BACKLIGHT FUNCTION
The backlight is turned on when receiving an incoming call, dialing,
pressing any key. It will fade off if the telephone is left idle for 6 seconds.
Note: If batteries are not loaded, there will be no LCD backlight function.
TIMER FUNCTION
Pick up the handset or press key and dial a number, then press DEL
key, the unit will start to time at once. Otherwise, it will time after 6
seconds automatically.
FLASH FUNCTION
When you dial a number and the line is engaged, press FLASH/÷ key
and then press REDIAL key to dial it out again.
PAUSE FUNCTION
If dial a number from PABX extension, press PABX number (normally “0”
or “9”) + ALARM/P + desired number. When redial, need not dial PABX
number and ALARM/P key, just press REDIAL key.
BABYCALL FUNCTION
At on-hook state, press and hold REDIAL key for 3 seconds to come into
baby call function setting. LCD displays BABYCALL OFF, press UP/+ or
DOWN/– key to set it ON or OFF, press SET key to confirm. If you select
ON, LCD displays NO CODE (or the preset baby call number, press DEL
key to cancel), input baby call number using numerical key and press
To Next Page
