Teledex E103IP - Dsp; System; Other Setting; Setting Catalog

12
1) Public
2) Private
2.3.4.5 Detect-server
2.3.4.6 Dtmf-mode
2.3.4.7 Interval-time
2.3.4.8 Swap-server
2.3.4.9 RFC-version
2.3.4.10 Signal-Port
2.3.4.11 Stun
1) Switch
2) Addr
3) Port
4) Expire Time
2.3.5 DSP
2.3.5.1 Codec
2.3.5.2 Handdown-time
2.3.5.3 Dtfm-Volume
2.3.5.4 Input-Volume
2.3.5.5 Output-Volume
2.3.6 System
2.3.6.1 Save
2.3.6.2 Reboot
2.3.6.3 Set Default
2.3.7 Other Setting
2.3.7.1 Syslog
1) Switch
2) Server-IP
3) Server-Port
2.3.8 Setting catalog
1. Pressing down the “Menu” key to enter the setting status of speed dial key
and input the needed saving No., then press the corresponding speed dial key to
save.
2. Pressing down “Menu” above 3 seconds to enter the setting status and the
default keyword is 123, and then you can press “Enter” to enter, “Menu” to exit.
3. When modifying the setting, press “Redial” to enter modification status, and
“0” is to make no choice, “1” is to make choice, “Enter” is to confirm the modification,
and “Menu” is to quit the modification. After finished the modification setting, we
will save it on “Save” menu. After rebooting all the settings will be go into effect.