Teledyne Lecroy Quantumdata 780E - Video Interfaces

780E Video Generator / Analyzer – Quick Start Guide Page 4
September 13, 2018
P/N 68-00231 - Rev. B1
2 Physical Interfaces of the 780E Protocol Analyzer / Generator
This section describes the administration, video and audio interfaces on the 780E test instrument.
2.1 Video Interfaces
Table 2-1 below describes the video interfaces on the 780E test instrument, these interfaces are used to render test
patterns for testing consumer electronic HDTVs and computer displays.
Table 2-1: 780E Video Interfaces
Video Interface
Description
HDMI (1) Output Type A
Single link HDMI output connector.
 Bit Depth: 24/30/36 bit.
 Colorimetry: RGB, YCbCr.
 Sampling: 4:4:4 and 4:2:2.
 Pixel rate: Timings up to 4K x 2K – 600MHz.
 DVI support through HDMI to DVI adapter cable (RGB, 4:4:4, 24 bit).
 Audio: LPCM, Dolby Digital and DTS.
HDMI (1) Input Type A
Single link HDBaseT input connector.
 Colorimetry: RGB, YCbCr.
 Sampling: 4:4:4 and 4:2:2.
 Pixel rate: Timings up to 4K x 2K – 600MHz.
DisplayPort Output Standard Connector
(Optional with 780E P/N 00-00251)
Single link HDBaseT output connector.
 Bit Depth: 18/24/30/36/48 bit.
 Colorimetry: RGB, YCbCr.
 Sampling: 4:4:4 and 4:2:2.
 Link Rates: 1.62, 2.70, 5.40 Gb/s.
 Lanes: 1,2,4
 Audio: LPCM.
DisplayPort Input Standard Connector
(Optional with 780E P/N 00-00251)
Single link HDMI input connector.
 Colorimetry: RGB, YCbCr.
 Sampling: 4:4:4 and 4:2:2.
 Link Rates: 1.62, 2.70, 5.40 Gb/s.
 Lanes: 1,2,4
HDBaseT (1) Output RJ45
Single link HDBaseT output connector.
 Bit Depth: 24/30/36 bit.
 Colorimetry: RGB, YCbCr.
 Sampling: 4:4:4 and 4:2:2.
 Pixel rate: Timings up to 4K x 2K - 300MHz.
 Audio: LPCM, Dolby Digital and DTS.
HDBaseT (1) Input RJ45
Single link HDMI input connector.
 Colorimetry: RGB, YCbCr.
 Sampling: 4:4:4 and 4:2:2.
 Pixel rate: Timings up to 4K x 2K - 300MHz.