Need help?Do you have a question about the Teledyne VISION G2 CLASSIC 6 and is the answer not in the manual?
General| Brand | Teledyne |
|---|---|
| Model | VISION G2 CLASSIC 6 |
| Category | Test Equipment |
| Language | English |
Identifies key components of the Vision G2 Classic 6 and Elite 8 testers.
Explains how to interact with the Vision G2 tester software and its input methods.
Compares standard features available for Vision G2 Classic 6 and Elite 8 models.
Outlines general safety precautions and warnings for operating the equipment.
Details safety requirements specific to CSA standards, including environmental limits.
Provides information on the apparatus's compliance with Canadian radio noise regulations.
Specifies suitable locations and environmental conditions for tester installation.
Details power supply needs, voltage configurations, and power cord specifications.
Provides instructions for safely unpacking and inspecting the Vision G2 dissolution tester.
Guides on connecting power to the Vision tester and heater units.
Instructions for installing the Vision Heater and connecting it to the tester.
Illustrates tubing connections between the bath and the heater for Classic 6 and Elite 8.
Guides on running the Vision tester's diagnostic procedure for self-testing functionality.
Accesses system logs and basic information about the Vision tester via the Info screen.
Describes access to event, test, and error logs via the Instrument Logs screen.
Allows users to enter serial numbers for connected components like testers, heaters, and printers.
Details how to update service logs for calibration, maintenance, and operational hours.
Allows adjustment of screen brightness and volume through the Touchscreen Settings screen.
Guides on configuring the Vision tester for communication and accessories via Device Setup.
Describes the screens that appear when starting a test, including navigation buttons.
Allows entry of specific information for each test run, appearing on printed reports.
Configures test-specific options like report printing, heater behavior, and auto-start settings.
Step-by-step guide for initiating a quick test run using the Quick Start function.
Detailed instructions on initiating a dissolution test, including protocol selection and header info.
Outlines maintenance activities categorized by frequency: After Each Test, Weekly, Monthly, etc.
Detailed steps for inspecting and replacing o-rings on the spindle shafts.
Instructions for removing, replacing, and tensioning drive belts for the testers.
Guides on adjusting temperature probe offsets using an NIST traceable thermometer.
Procedure for adjusting spindle shaft height for proper apparatus positioning.
Guidelines for safely moving, storing, and cleaning the dissolution tester.
Information on how to contact technical support and what details to provide.
Lists common electrical problems and their recommended solutions for the tester.
Addresses mechanical issues like vibration and incorrect paddle/basket heights.
Troubleshooting steps for heater communication and temperature-related errors.
Solutions for issues related to AutoMag/SuperMag movement and probe functionality.
Guides for resolving problems with serial printers, including paper and connection issues.
Troubleshooting steps for network printers, focusing on IP address and PostScript support.
Provides weight, size, bath capacity, and power details for the Classic 6 model.
Lists weight, size, bath capacity, and power details for the Elite 8 model.
Details weight, size, and power specifications for the Vision G2 Heater.
Summarizes general performance specs like spindle speed, temperature control, and probe accuracy.
Lists materials used for wetted parts, including part numbers and descriptions.
Details specific error codes, messages, faults, and troubleshooting checks for Vision testers.
Lists error codes, messages, and fault checks related to the Vision Heater.
Describes how Vision G2 testers and samplers communicate via TCP/IP protocols.
Specifies the required firmware version for compatibility with Waters Alliance systems.
Explains how call events execute event libraries within dissolution test protocols.
To Next Page
