Teledyne Reson PDS User Manual

Name: Teledyne Reson PDS
Brand: Teledyne
Rating: 4 (1 reviews)

75 pages

To Next Page

Teledyne PDS, T20-P and POS MV Quick Setup

Teledyne PDS

Version 1.0.6

June 2015

Teledyne RESON B.V.

Stuttgartstraat 42- 44

3047 AS Rotterdam

The Netherlands

Tel.: +31 (0)10 245 15 00

www.teledyne-reson.com

Table of Contents3
Introduction7
T20-P with POS MV and Teledyne PDS Quick Setup7
Interfacing9
Introduction9
Connections9
Figure 2-1 Rear Panel RESON T20-P9
Figure 2-2 Rear Panel Applanix POS MV9
Figure 2-3 Schematic of Interfacing RESON T20-P, Applanix POS MV and Teledyne PDS Computer10
Computer Requirements11
Installation12
Configuration13
Introduction13
Software Installation13
Teledyne PDS Installation13
Seabat User Interface (SUI)13
Posview13
TCP/IP Settings13
Configure Computer TCP/IP Settings and Disable Firewall14
Figure 3-1 Firewall17
Configure T20-P TCP/IP Settings20
Configure POS MV TCP/IP Settings23
SUI Configuration25
Roll Stabilization25
Time and PPS Setup26
Serial Time Message26
Figure 3-2 Hardware Pane with Motion Stabilization Setting26
Ethernet Time Message27
Figure 3-3 I/O Pane Serial Clock Setting27
Figure 3-4 Changing the Serial Protocol into Network27
Pps28
Figure 3-5 Clock Settings Using the Ethernet28
Sound Velocity29
Figure 3-6 Hardware Pane PPS Setting29
Figure 3-7 PPS Status LED29
Other I/O Settings30
POS MV Configuration30
Connect with POS MV30
Figure 3-8 I/O Pane Sound Velocity (COM3)30
Installation Settings31
Figure 3-9 Connect with POS MV31
Figure 3-10 Lever Arms & Mounting31
Figure 3-11 IMU Reference Point31
Figure 3-12 POS MV Lever Arms Convention32
Figure 3-13 Lever Arm & Mounting Angles32
Timing33
Serial Time Message Output33
Figure 3-14 Keep Ref. to Sensor 1 Values Zero33
Figure 3-15 Tags, Multipath & Autostart34
Figure 3-16 Time Tag UTC Time34
Figure 3-17 Input/Output Ports34
Ethernet Time Message35
Figure 3-18 Time Input/Output Ports Set-Up35
Figure 3-19 Tags, Multipath & Autostart36
Figure 3-20 Time Tag UTC Time36
Figure 3-21 Ethernet Realtime36
Motion37
Figure 3-22 PPS Data Selection37
Figure 3-23 Input/Output Ports37
Position38
Ethernet Output38
Figure 3-24 Motion Input/Output Set-Up38
Figure 3-25 Ethernet Realtime38
RTCM / CMR Input39
COM 3 PORT Input39
Figure 3-26 Logging Groups39
GNSS Port40
Figure 3-27 Input/Output Ports Set-Up40
Calibration41
Figure 3-28 GNSS Receiver41
Figure 3-29 GNSS Receiver Configuration41
Figure 3-30 GAMS Param Setup42
Figure 3-31 GAMS Parameter Setup42
Figure 3-32 Navigation43
Figure 3-33 GAMS Calibration Control43
Figure 3-34 Heading Accuracy44
Figure 3-35 GAMS Status44
Figure 3-36 Save Settings44
Teledyne PDS Configuration45
Equipment Selection45
Reson45
Figure 3-37 Equipment Page45
Figure 3-38 RESON Seabat 7K46
Figure 3-39 RESON Seabat 7K Devices46
Pos MV47
Figure 3-40 Positioning47
Figure 3-42 Compass49
I/O Selection50
Reson I/O50
Figure 3-43 Heave50
Posmv I/O54
Timing57
Clock Synchronization Set-Up58
Timestamp Mode58
Offsets and Corrections59
Figure 3-44 Timestamp Mode 7K59
Figure 3-41 VRU60
Figure 3-45 Offsets60
Appendix Installing Teledyne PDS63
Introduction63
Install Teledyne PDS63
Figure 4-1 Welcome Page of the Teledyne PDS Installshield Wizard63
Figure 4-2 Type of Setup in the Teledyne PDS Installshield Wizard64
Figure 4-3 Update C-Map SDK Software64
Appendix Installing Seabat User Interface (SUI)67
Introduction67
Vessel Configuration67
Appendix Installing Posview71
Introduction71
Installing Posview71

Questions and Answers:

Need help?

Do you have a question about the Teledyne Reson PDS and is the answer not in the manual?

Teledyne Reson PDS Specifications

General

Brand	Teledyne
Model	Reson PDS
Category	Test Equipment
Language	English

Related product manuals

Teledyne VISION G2 CLASSIC 6

Teledyne T3DSO1000A Series

227 pages

Teledyne Reson PDS User Manual

Table of Contents

Questions and Answers:

Teledyne Reson PDS Specifications

Related product manuals