TELEFONICA DOMO - Page 5

88
88
8
99
99
9
DOMO DOMO
DOMO DOMO
DOMO
MessaMessa
MessaMessa
Messa
gg
gg
g
es Hands Fes Hands F
es Hands Fes Hands F
es Hands F
rr
rr
r
eeee
eeee
ee
DOMO DOMO
DOMO DOMO
DOMO
MessaMessa
MessaMessa
Messa
gg
gg
g
es Hands Fes Hands F
es Hands Fes Hands F
es Hands F
rr
rr
r
eeee
eeee
ee
Press Desactivar/Salir (4) to return to
the normal display.
Press the Marcar/Menú key (21) until
the message appears in the viewer.
Press the pq keys (20) to increase
or decrease the contrast. The level
selected will be shown in the viewer.
Press the Desactivar/Salir key (4) to
return to the normal display.
Press the Marcar/Menú key (21) again
until PULSE HORA/FEC. Is displayed.
With the handset down adjust the hour
and date by typing them directly into
the keyboard. If you make a mistake,
use the Borrar key (17) to Erase.
For example, if the hour and date is
the 20th. of November and 2:11am,
type: 20100211.
Once the last digit of the date has
been typed, the new hour and date
will be displayed in the viewer. If the
process is not completed, the previous
and date will remain displayed.
After finishing this operation, you will
be able to select the next option by
pressing the Marcar/Menú (21) key
again, or return to the normal display
by pressing the Desactivar/Salir key
(4).
Remember, if you have the caller
Identification service enabled, when
receiving a call, the hour and date
display will be adjusted automatically.
Adjusting
the contrast
of the viewer
Setting the
hour and
dates
This Menu option lets you activate
or deactivate the beep tone, which
sounds when you press a key.
Press the Marcar/Menú key (21) until
the viewer shows one of the following
messages. If the beep has already
been activated, this message
appears in the viewer.
If the beep has already been de-
activated, this message appears in
the viewer.
Using the cursor keys pq(20) you
can activate or deactivate the beep.
Press the Desactivar/Salir key (4) to
return to the normal display in the
viewer.
This Menu option allows you hear
validation and error tones. The
validation tone is a long tone which
indicates that a function has been
executed correctly. If the operation
was incorrect, three short tones will
be heard.
Press the Marcar/Menú key (21) until
the viewer shows one of the following
messages. If the validation and error
tones are activated, this message is
shown in the viewer.
If the tones are disabled, this
message is shown in the viewer.
Using the cursor keys pq (20) you
can activate or deactivate the
validation and error tones.
Press the Desactivar/Salir key (4) to
return to the normal display in the
viewer.
Tone
confirmation
of a pressed
key
Validation
and error
tones
CONTRAST. é ê
HORA/FEC PULSE.
HORA/FEC PULSE.
SONIDOS TECLA: SI
SONIDOS TECLA: NO
SONIDOS V/E: SI
SONIDOS V/E: NO