Telematrix 3300LBY - 3300 Series Programming; Storing Numbers into Memory Keys; Programming Flash and Pause Timing; Storing Pause;Redial into Memory

8 www.telematrix.net 3300 SERIES ANALOG USER GUIDE
Flash timing is 600 mS. Pause timing options are
1.0s through 5.0 s. The default Pause timing is 3.6s.
1. Lift the handset.
2. Press the STORE key once.
3. Program FLASH by pressing “1” for 100 mS,
“2” for 200 mS, and so on.
4. Press STORE.
5. Press FLASH.
6. Exit programming by hanging up the
handset.
To program PAUSE follow the above sets, except at
#3 do the following:
3. Program PAUSE by pressing “1” for 1.0 s,
“2” for 2.0 s, and so on.
STORING PAUSE/REDIAL INTO
MEMORYPAUSE
If you are using your telephone anywhere that
requires an access code for outside calls, you may
need to add a PAUSE to the number to allow time
for the outside line to connect. You can enter an
many pauses as needed.
Note: A PAUSE or FLASH programmed into
memory counts as one digit when storing a
number.
1. Lift the handset.
2. Press the STORE key.
3. Enter the required access code using the
dial pad.
4. Press the PAUSE key.
5. Enter the digits to be stored using the
numeric dial pad.
6. Press the desired memory location wherein
the number is to be stored.
7. If additional numbers are to be stored,
repeat steps 3 through 7.
8. Hang up the handset.
(Does not apply to non-memory key telephones.)
The telephone line will activate automatically.
The SPEAKER key will light up indicating that the
speakerphone is in-use. To hang up, press the
SPEAKER key again.
(Does not apply to non-speakerphone telephones.)
Programming
The telephone set must be connected to the PBX
in order to program it.
TO PROGRAM STORE, FLASH, AND PAUSE
Some of these programming keys are located
under the faceplate and overlay. Begin by lifting
up the faceplate and overlay by using either a
paperclip or sharp pointer.
STORING A NUMBER INTO MEMORY
KEYSSTORE
Each location can store up to 32 digits in tone
mode.
Note: A PAUSE or FLASH programmed into
memory counts as one digit when storing a
number.
1. Lift the handset.
2. Press the STORE Key.
3. Enter the number to be stored using the
numeric dial pad.
4. Press the desired memory location wherein
the number is to be stored.
5. If additional numbers are to be stored,
repeat steps 3 through 5.
6. Hang up the handset.
(Does not apply to non-memory key telephones.)
PROGRAMMING FLASH TIMING AND
PAUSE TIMING
Flash timing options are 100 mS thru 1000 mS,
programmable in 100 mS increments. The default