26
User´s Manual Universal Remote Control
HOW TO INSTALL BATTERIES
Alkaline batteries recommended. The number of battery required stated at the
back of the coversheet.
1.- Remove the battery cover on the back of your URC.
2.- Observe the polarity of the batteries and the “+/-” marks inside the battery
compartment.
3.- lnsert the batteries.
4.- Push the battery cover back in place.
Battery Low
If the indicator flashes 6 times after you
invoking of any command, it shows that
the battery level is low. You must replace
them with new batteries to ensure proper
functioning.
HOW TO SET UP THE URC (PRE-PROGRAMMED BRAND CODES)
By entering DEVICE CODE
You may setup the URC by following code entering instructions.
Refer to the DEVICE CODE LIST, look up the 4-digit Device Code which corres-
ponds to the brands of your A/V equipment. lf there is more than one Device
Code listed under your brand, try from the first code:
For example:
Turn on your device (e.g. TV), try the function keys on the URC. lf your device
(e.g. TV) responds to your invoked function correctly, you have entered the right
Device Code. Otherwise, repeat the above setup instructions with the rest availa-
ble Device Codes until your device (e.g. TV) responds to your invoked function,
and most keys work correctly.
Simply repeat the above procedures to enter the Device Codes for your VCR,
SAT, DVD or CTV (Remember to press a correct Device Mode key in step 1
above).
Note:
- DVD, CTV and other Device Codes can be entered into any device modes
except "TV" & "VCR" modes. Just simply press the device mode key and enter
your 4-digit device code for DVD, CTV, etc..
- lf the indicator flashes 6 times in step 3, a wrong Device Code has been ente-
red. You are required to repeat step 1 to 3 again.
Suggestion:
- lf you cannot find a correct Device Code for your equipment, see Setup by the
SEARCH THROUGH THE LIBRARY section.
- You are recommended to jot down your Device Codes in the space provided on
the back label after setting up the URC correctly for future reference.
1.- Press the desired
Device Mode Key
(e.g. TV).
2.- Hold down &
on the URC
together simultane-
ously for 2 seconds
until the indicator
flashes twice.
3.- Use the numeric keys
to enter your 4-digit
Device Code, the
indicator should flash
twice.
2
1
3
To Next Page
Loading...