29
User´s Manual Universal Remote Control
ENGLISH
Warning:
Entering a new pre-programmed Device Code will automatically erase and
replace all learned commands in the chosen device mode.
Note:
- Do not attempt to learn additional commands with the device mode keys and
the “SHIFT” key. They will not hold commands by themselves.
- Each function key will hold one command only, a new command to be learned
will automatically erase and replace the previous one.
- lf you have accidentally pressed an unexpected key in step 5 above, you have
to wait 30 seconds until the indicator goes out and the URC will go back to
normal operation. You may repeat the above procedures to setup the URC
again.
- If you intend to operate more than 4 equipment, you may learn and store sig-
nals with the 4 secondary device modes. See ADVANCED OPERATION -
Secondary Device Mode section for entering a proper secondary device mode
in step 2 above.
- Signals can be taught into the secondary function of a key. See ADVANCED
OPERATION section.
- lf the indicator flashes 6 times during the transference of signals, the maximum
120 commands memory bank is full, press the same device key again to resu-
me normal operation.
You may erase the learned commands in a device mode and make room for
any new signal. See WARNING above.
OPERATING THE URC
Normal Operation
Once you have set up the URC for your A/V equipment, it works like your original
remote controls. To operate, just aim it at your equipment, press an appropriate
device mode key and invoke the desired function by pressing a corresponding
key on the URC. The indicator flashes during signal transmission and as confir-
mation of key touch.
Punch Through
Punch through allows you to operate the TV's volume and mute functions wit-
hout having to switch the device modes repeatedly even when your URC is in
other operating modes.
ADVANCED OPERATION
Secondary Function
Symbols of secondary function are printed in different colors on the panel, and a
SECONDARY FUNCTION TABLE is included in the interior page of the covershe-
et. To invoke a secondary function, press “SHIFT” followed by a corresponding
function key.
Secondary Device Mode
1.- lf you intend to operate more than 3 (or 4) equipment with your URC, you may
search/enter the additional device codes.
Following all standard procedures in setting up the URC (See HOW TO
SETUP THE URC), press “SHIFT” followed by a desired device mode key to
enter a secondary device mode. All settings will be stored in the shift bank of
such device mode.
2.- To invoke functions stored inside the shift bank of a device mode, press
“SHIFT” followed by the device mode key, your URC will stay on that particu-
lar operating mode.
To Next Page
Loading...