Telex Stratus 30XT - Battery Charging; Disabling Auto Shut-Off; Reading the LED Indicator

Page 6
Battery Charging (Stratus 30XT only)
To charge the batteries, connect either the AC wall adapter or the aircraft
cigarette lighter adapter to the DC input jack. If the headset is off, the LED will
light solid red during charging. If the unit is on and the batteries are charging,
the LED will be mostly on but blink off occasionally, as opposed to being
mostly off but blinking on occasionally when the batteries are not charging.
Disabling Auto Shut-Off
To disable the Auto Shut-Off feature, remove the batteries (see Battery
Installation) and locate the DIP switch in the battery compartment. Using a
small flat-blade screwdriver, set switch position 3 away from the number 3.
Auto Shut-Off can be re-enabled by sliding switch position 3 toward the
number 3.
Figure 8
Disabling Auto Shut-off
lamroNyrettaBwoLyrettaB
gnigrahCyrettaB
)ylnoTX03sutartS(
ffOrewoP
ffODELffODELdeRdiloSDEL
/nOrewoP
delbanEseirosseccA
2yreveneerGsknilB
.ces
2yrevedeRsknilB
.ces
yreveffosknilB,neerG
.ces2
/nOrewoP
detuMseirosseccA
4yreveneerGsknilB
.ces
4yrevedeRsknilB
.ces
yreveffosknilB,neerG
.ces4
Reading the LED Indicator