HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 47 of 229
+CSCS - Select TE Character Set
to FF; e.g. “032FE6” equals three 8-bit characters with decimal values 3,
47 and 230; no conversions to the original MT character set shall be done.
“IRA” International reference alphabet (ITU-T T.50 [13]). (factory
default)
“UCS2” 16-bit universal multiple-octet coded character set
(ISO/IEC10646 [32]); UCS2 character strings are converted to
hexadecimal numbers from 0000 to FFFF; e.g. “004100620063” equals
three 16-bit characters with decimal values 65, 98 and 99.
AT+CSCS?
Read command returns the current value of the active character set.
AT+CSCS=?
Test command returns the supported values for parameter <chset>.
Reference 3GPP TS 27.007
3.5.3.1.6. Request International Mobile Subscriber Identity (IMSI) - +CIMI
+CIMI - Request International Mobile Subscriber Identify (IMSI)
AT+CIMI
Execution command returns the value of the Internal Mobile Subscriber Identity
stored in the SIM without command echo.
Note: a SIM card must be present in the SIM card housing, otherwise the command
returns ERROR.
AT+CIMI=?
Test command returns OK result code.
Reference 3GPP TS 27.007
To Next Page
Loading...
