HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 18 of 229
3.2.3. Information Responses And Result Codes
The TA response, in case of verbose response format enabled, for the previous examples
command line could be as shown below:
Information response to +CMD1? <CR><LF>+CMD1:2,1,10<CR><LF>
Information response to +CMD1=? <CR><LF>+CMD1(0-2),(0,1),(0-15)<CR><LF>
Final result code <CR><LF>OK<CR><LF>
Moreover there are other two types of result codes:
result codes that inform about progress of TA operation (e.g. connection
establishment CONNECT)
result codes that indicate occurrence of an event not directly associated with issuance
of a command from TE (e.g. ring indication RING).
Here the basic result codes according to ITU-T V25Ter recommendation
Result Codes
Numeric form Verbose form
0 OK
1 CONNECT
2 RING
3 NO CARRIER
4 ERROR
6 NO DIALTONE
7 BUSY
8 NO ANSWER
To Next Page
Loading...
Need help?
General
