Need help?Do you have a question about the Telit Wireless Solutions LN940A11 SERIES and is the answer not in the manual?
General| Manufacturer | Telit Wireless Solutions |
|---|---|
| Operating Temperature | -40°C to +85°C |
| GNSS | GPS, GLONASS, BeiDou, Galileo |
| Model | LN940A11 |
| Frequency Bands | B1/B2/B3/B4/B5/B8/B12/B13/B18/B19/B20/B25/B26/B28/B66 |
| Interface | GPIO |
| Certifications | CE, FCC, PTCRB, GCF |
Covers significant standard and proprietary AT commands for Telit modules.
Provides contact details for technical support and documentation feedback.
Details the "AT" prefix, termination, and response format.
Command to repeat the previous AT command line.
Determines the character for terminating an AT command line.
Saves current AT command settings to non-volatile memory.
Delivers product identification information text.
Returns the manufacturer identification text.
Returns the International Mobile Equipment Identity (IMEI).
Indicates networks in which the TA can operate.
Selects bearer service, data rate, and connection element for data calls.
Returns MSISDNs related to the subscriber.
Controls presentation of unsolicited network registration results.
Forces an attempt to select and register a network operator.
Returns the activity status of the MT.
Selects the level of functionality in the MT.
Sends a password (PIN) to the MT for operation.
Specifies PDP context parameter values for a PDP context.
Attaches or detaches the MT from the Packet Domain service.
Controls presentation of unsolicited EPS network registration status.
Specifies EPS Quality of Service parameters.
Selects the messaging service and returns supported message types.
Specifies the input and output format of short messages.
Sends a message from TE to the network (SMS-SUBMIT).
Sets the TE-DCE baud rate.
Sets the primary DNS IP address.
Powers down the UE.
Resets the target device.
Retrieves the IMEI value.
Retrieves the firmware version, including AP version.
To Next Page
