80591ST10886A Rev.2 Page 67 of 200 2018-07-02
<command> Command passed on by the MT to the SIM in the format as described in GSM 51.011
[28] (hexadecimal character format; refer +CSCS)
Example
AT+CSIM=14,”00A40004023F00”
+CSIM: 4,”6122”
OK
9.7.
AT+CRSM Restricted SIM Access
By using this command instead of Generic SIM Access +CSIM TE application has easier but more limited
access to the SIM database. Set command transmits to the MT the SIM <command> and its required
parameters. MT handles internally all SIM-MT interface locking and file selection routines. As response to the
command, MT sends the actual SIM information parameters and response data. MT error result code +CME
ERROR may be returned when the command cannot be passed to the SIM, but failure in the execution of the
command in the SIM is reported in <sw1> and <sw2> parameters. Coordination of command requests to SIM
and the ones issued by GSM/UMTS application inside the MT is implementation dependent. However the TE
should be aware of the precedence of the GSM/UMTS application commands to the TE commands.
Syntax
Test Command AT+ CRSM =? OK -
Write Command AT+ CRSM =
<command>[,<fileid>
[,<P1>,<P2>,<P3>
[,<data>[,<pathid>]]]]
+CRSM:
144,0,”6232820278218410A0000000871002FF86
FFFF89FFFFFFFF8A01058B062F0601010001C6
0F9001A0950100830111830101830181”
OK
-
Parameter Description
To Next Page
Loading...
