Telit Wireless Solutions LN940A11 SERIES - Mobile Equipment Commands; AT+CPAS Phone Activity Status; AT+CFUN Set Phone Functionality

80591ST10886A Rev.2 Page 62 of 200 2018-07-02
9. MOBILE EQUIPMENT COMMANDS
9.1. AT+CPAS Phone Activity Status
Execution command returns the activity status <pas> of the MT. It can be used to interrogate the MT before
requesting action from the phone.
Test command returns values supported by the MT as a compound value.
Syntax
Type
Command
Possible Return Result
Instruction
Execute
Command
AT+ CPAS +CPAS: <stat>
OK
-
Test Command AT+ CPAS =? +CPAS: (0,3,4)
OK
-
Parameter Description
parameter
Value
Instruction
<stat> 0
Ready (MT allows commands from TA/TE)
3
Ringing (MT is ready for commands from TA/TE, but the ringer is active)
4
Call in progress (MT is ready for commands from TA/TE, but a call is in progress)
9.2. AT+CFUN Set Phone Functionality
This set command selects the level of functionality <fun> in the MT. Level “full functionality” is where the highest
level of power is drawn. “Minimum functionality” is where minimum power is drawn. Level of functionality
between these may also be specified by manufacturers. When supported by manufacturers, MT resetting with
<rst> parameter may be utilized.