Telit Wireless Solutions LN940A11 SERIES - ATQCPDPP Set Authentication for PDP-IP

80591ST10886A Rev.2 Page 124 of 200 2018-07-02
<address> <0-254>.<0-254>.<0-
254>.<0-254>
13.6. AT$QCPDPP Set Authentication for PDP-IP
AT$QCPDPP command is used to set authentication for PDP-IP packet data calls.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT$QCPDPP=? $QCPDPP: (1-24),(0-3),,
OK
Read Command AT$QCPDPP? $QCPDPP: <cid>,<auth_type>
OK
Write Command
AT$QCPDPP=<cid>,<aut
h_type>,<password>,<us
ername>
OK
Parameter Description
parameter
Value
Instruction
<cid> 1 to 24
Parameter specifies a particular PDP context definition. This
is also used in other PDP context-related commands.
<auth_type> 0 None
1 PAP
2 CHAP
<password> Parameter specifies the password used for authentication. It
is required for the authentication types PAP and CHAP.
<username>
Parameter specifies the user name used for authentication. It
is required for the authentication types PAP.