Telit Wireless Solutions LN940A11 SERIES User Manual

80591ST10886A Rev.2 Page 74 of 200 2018-07-02
10.2. AT+CGDSCONT Define Secondary PDP Context
The set command specifies PDP context parameter values for a Secondary PDP context identified by the
(local) context identification parameter, <cid>. The number of PDP contexts that may be in a defined state at
the same time is given by the range returned by the test command.
A special form of the set command, +CGDSCONT= <cid> causes the values for context number <cid> to
become undefined
The read command returns the current settings for each defined context.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+ CGDSCONT =? +CGDSCONT: (1-24),(),”IP”,(0-3),(0-4)
+CGDSCONT: (1-24),(),”PPP”,(0-3),(0-4)
+CGDSCONT: (1-24),(),”IPV6”,(0-3),(0-4)
+CGDSCONT: (1-24),(),”IPV4V6”,(0-3),(0-
4)
OK
-
Read Command AT+ CGDSCONT? +CGDSCONT:
OK
-
Write Command
AT+ CGDSCONT =[<cid>, <p_cid>,
[,<d_comp> [,<h_comp>]]]
OK -
Parameter Description
parameter
Value
Instruction
<cid> 1-24
(PDP Context Identifier) A numeric parameter which specifies a particular PDP
context definition. The parameter is local to the TE-MT interface and is used in other
PDP context-related commands. The range of permitted values (minimum value = 1)
is returned by the test form of the command
<p_cid> 1-24
(Primary PDP Context Identifier) a numeric parameter which specifies a particular
PDP context definition which has been specified by use of the +CGDCONT command.

Telit Wireless Solutions LN940A11 SERIES Specifications

General

Brand	Telit Wireless Solutions
Model	LN940A11 SERIES
Category	Control Unit
Language	English