Telit Wireless Solutions LN940A11 SERIES - AT+CRLP Configure RLP Parameters for Outgoing Non-Transparent Data Calls

80591ST10886A Rev.2 Page 40 of 200 2018-07-02
83 56000 bps (V.110 or X
.31 flag stuffing; this setting can be used
in conjunction with asynchronous non-transparent UDI or RDI
service in order to get FTM)
84 64000 bps (X.31 flag stuffing; this setting can be used in
conjunction with asynchronous non-transparent UDI service in
order to get FTM)
116 64000 bps (bit transparent)
134 64000 bps (multimedia)
<name>
0 Asynchronous Modem
1 Synchronous Modem
4 Asynchronous Modem (RDI)
<ce>
0 Transparent
1 Non-transparent
Example:
at+cbst=14,0,1
OK
at+cbst=?
+CBST: (0,7,12,14,16,17,39,43,48,51,71,75,80,81,83,84,116,134),(0,1,4),(0,1)
OK
6.5. AT+CRLP Configure RLP Parameters for Outgoing Non-Transparent Data
Calls
AT+CRLP write command sets radio link protocol (RLP) parameters used when non-transparent data calls are
originated. The read command returns the current settings for the supported RLP version 0 till 2.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+CRLP=?
+CRLP: (list of supported <iws>s),(list of supported
<mws>s),
(list of supported <T1>s),(list of supported <N2>s)[,<ver1>
[,(list of supported <T4>s)]]
-