Telit Wireless Solutions LN940A11 SERIES - AT+CGEQOSRDPEPS Quality of Service Read Dynamic Parameters; AT+CGTFTRDP Traffic Flow Template Read Dynamic Parameters

80591ST10886A Rev.2 Page 97 of 200 2018-07-02
Parameter Description
parameter
Value
Instruction
<cid> 1-24
A numeric parameter which specifies a particular PDP context or Traffic
Flows definition. The parameter is local to the TE-MT interface and is used in
other PDP context-related commands (see the +CGDCONT and
+CGDSCONT commands.
11.5. AT+CGTFTRDP Traffic Flow Template Read Dynamic Parameters
The execution command returns the relevant information about Traffic Flow Template of <cid> together with the
additional network assigned values when established by the network. If the context cannot be found an ERROR
response is returned.
If the parameter <cid> is omitted, the Traffic Flow Templates for all established PDP contexts are
returned.Parameters of both network and MT/TA initiated PDP contexts will be returned.
The test command returns a list of <cid>s associated with active contexts.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+ CGTFTRDP=? OK -
Write Command AT+ CGTFTRDP =[<cid>] OK -
Parameter Description
parameter
Value
Instruction
<cid> 1-24
Specifies a particular secondary or non secondary PDP context definition or
Traffic Flows definition (see +CGDCONT and +CGDSCONT commands).
11.6. AT+CGEQOSRDPEPS Quality of Service Read Dynamic Parameters