Telit Wireless Solutions LN940A11 SERIES - AT+CGSCONTRDP Secondary PDP Context Read Dynamic Parameters

80591ST10886A Rev.2 Page 96 of 200 2018-07-02
Type
Command
Possible Return Result
Instruction
Test Command AT+ CGCONTRDP=? +CGCONTRDP: ( 1 )
OK
-
Write Command AT+ CGCONTRDP =[<cid>]
+CGCONTRDP:
1,5,3gnet,10.227.12.5,,210.21.
196.6,221.5.88.88
OK
-
Parameter Description
parameter
Value
Instruction
<cid> 1-24
A numeric parameter which specifies a particular non secondary PDP context
definition. The parameter is local to the TE-MT interface and is used in other
PDP context-related commands(see the +CGDCONT and +CGDSCONT
commands.).
11.4. AT+CGSCONTRDP Secondary PDP Context Read Dynamic Parameters
The execution command returns <p_cid>, <bearer_id> and <IM_CN_Signalling_Flag> for a given <cid>. If the
context cannot be found an ERROR response is returned.
If the parameter <cid> is omitted, the <cid>, <p_cid>, <bearer_id> an<IM_CN_Signalling_Flag> are returned for
all established PDP contexts.In EPS, the Traffic Flow parameters are returned.
NOTE: Parameters for network initiated PDP contexts are returned as well. The dynamic part of the PDP
context will only exist if established by the network.
The test command returns a list of <cid>s associated with active contexts.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+ CGSCONTRDP=? OK -
Write Command AT+ CGSCONTRDP =[<cid>] OK -