Telit Wireless Solutions LN940A11 SERIES - AT+CGPADDR Show PDP Address

80591ST10886A Rev.2 Page 89 of 200 2018-07-02
parameter
Value
Instruction
<L2P>
A string parameter that indicates the layer 2 protocol to be used between the
TE and MT
NULL
none, for PDP type OSP:IHOSS (Obsolete)
PPP
Point-to-point protocol for a PDP such as IP
PAD
character stream for X.25 character (triple X PAD) mode (Obsolete)
X25
X.25 L2 (LAPB) for X.25 packet mode (Obsolete).
M-xxx
manufacturer-specific protocol (xxxx is an alphanumeric string).
<cid> 1-24
Specifies a particular PDP context definition (see the +CGDCONT and
+CGDSCONT commands).
10.11. AT+CGPADDR Show PDP Address
The execution command returns a list of PDP addresses for the specified context identifiers.
The test command returns a list of defined <cid>s.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+ CGPADDR=? +CGPADDR: (1)
OK
-
Write Command AT+ CGPADDR = [<cid> [,<cid> [,…]]] +CGPADDR: 1,10.226.85.88
OK
-
Parameter Description
parameter
Value
Instruction
<cid> 1-24
Specifies a particular PDP context definition (see the +CGDCONT and
+CGDSCONT commands).