Telit Wireless Solutions LN940A11 SERIES - 13.41. ATMODE Executes Parameter Register; ATQCCOPS Operator Selection

80591ST10886A Rev.2 Page 150 of 200 2018-07-02
Read Command AT$QCCOPS $QCATMOD: <port_e_type>,<
at_state >
OK
Parameter Description
parameter
Value
Instruction
<port_e_type> 0 – 12
< at_state > 0 – 3
13.40. AT$QCCOPS Operator Selection
AT$QCCOPS same as +COPS command and only exception is that PLMN can be specified in automatic
PLMN selection mode as well.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT$QCCOPS =? $QCCOPS: (list all current operator)
OK
Read Command AT$QCCOPS $QCCOPS:[<mode>[,<format>[,<op
er>[,<AcT>]]]]
OK
Parameter Description
parameter
Value
Instruction
<mode> 0 – 12
<format> 0 – 3
13.41. AT^MODE Executes Parameter Register
AT^MODE is Controls the presentation of ^MODE unsolicited result code