Telit Wireless Solutions LN940A11 SERIES - ATV Result Code Format Mode; ATX Connect Result Code Format

80591ST10886A Rev.2 Page 21 of 200 2018-07-02
<n> [0]
UE transmits result code. It is not recommended to change this
value.
1
Result codes are suppressed and not transmitted.
4.6. ATV Result Code Format Mode
This command determines the contents of header and trailer transmitted with AT command result codes and
information responses
Syntax
Type
Command
Possible Return Result
Instruction
Exec Command ATV[<value>] OK -
Parameter Description
parameter
Value
Instruction
<value> 0 Information response: <text><CR><LF>
Short result code format: <numeric code><CR>
1
Information response: <CR><LF><text><CR><LF> Long
result code format: <CR><LF><verbose code><CR><LF>
4.7. ATX Connect Result Code Format
ATX determines whether or not the device transmits particular result codes to the TE.
ATX also controls whether or not the UE verifies the presence of a dial tone when it begins dialing, and if
engagedtone (busy signal) detection is enabled.
The CONNECT result code indicates that the UE has changed from command state to online data state.
Syntax
Type
Command
Possible Return Result
Instruction
Exec Command ATX[<value>] OK -