Telit Wireless Solutions LN940A11 SERIES - AT+FTM Set the Operating Mode

80591ST10886A Rev.2 Page 171 of 200 2018-07-02
AT^SLMODE=1,4
OK
AT^SLMODE?
^SLMODE:1,4-Determine Mode Automatically
OK
AT^SLMODE=?
^SLMODE0,1),(4 ,14 ,30 ,35)
OK
AT^SLMODE
OK
Note
• You should set the target at ONLINE mode (AT+CFUN=1).
• When the PREF_TERM equals to 0, it won’t work after RESET.
15.15. AT+FTM Set the Operating Mode
AT+ FTM command is used to set the operating mode of module. The operating mode include ONLINE
and FTM mode.
Syntax
Type
Command
Possible Return Result
Instruction
Read Command AT+FTM? Device is in: <oper_mode>
OK
Write Command AT+FTM=<oper_mode> OK
Parameter Description
parameter
Value
Instruction