Telit Wireless Solutions LN940A11 SERIES User Manual

80591ST10886A Rev.2 Page 98 of 200 2018-07-02
The execution command returns the Quality of Service parameters <QCI>, [<DL_GBR> and <UL_GBR>] and
[<DL_MBR> and <UL_MBR>]of the established PDP Context associated to the provided context identifier
<cid>. If the context cannot be found an ERROR response is returned.
If the parameter <cid> is omitted, the Quality of Service parameters for all established PDP contexts are
returned.
The test command returns a list of <cid>s associated with active contexts.
Parameters of both network and MT/TA initiated PDP contexts will be returned.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+ CGEQOSRDP=? OK -
Write Command AT+ CGEQOSRDP =[<cid>] OK -
Parameter Description
parameter
Value
Instruction
<cid> 1-24
Specifies a particular Traffic Flows definition in EPS and a PDP Context
definition in UMTS/GPRS (see the +CGDCONT and +CGDSCONT
commands).
11.7. AT+CNMPSD No More PS Data
This command indicates that no application on the MT is expected to exchange data.
When in UTRAN, if further conditions defined in 3GPP TS 25.331 [74] are met, this can cause
transmission of a SIGNALLING CONNECTION RELEASE INDICATION message with the cause
“UE Requested PS Data session end”.
When in E-UTRAN, if further conditions defined in 3GPP TS 36.331 [86] are met, this can cause
transmission of a UEAssistanceInformation message with powerPrefIndicationset to
“lowPowerConsumption”to the network. Only WCDMA or TD-SCDMA are supported.

Telit Wireless Solutions LN940A11 SERIES Specifications

General

Brand	Telit Wireless Solutions
Model	LN940A11 SERIES
Category	Control Unit
Language	English