Telit Wireless Solutions LN940A11 SERIES - ATE at Command Echo; ATQ Result Code Presentation Mode

80591ST10886A Rev.2 Page 20 of 200 2018-07-02
parameter
Value
Instruction
<n> 0~127 Default value is 8.
Command line editing character.
It is not recommended to change this value.
4.4. ATE AT Command Echo
ATE controls if the device echoes characters received from TE during AT command state..
Syntax
Type
Command
Possible Return Result
Instruction
Exec Command ATE[<value>] OK -
Parameter Description
parameter
Value
Instruction
<value> 0 Echo mode off
1 Echo mode on
4.5. ATQ Result Code Presentation Mode
ATQ controls if the device transmits any result code to the TE. Other information text transmitted as response is
not affected.
Syntax
Type
Command
Possible Return Result
Instruction
Exec Command ATQ[n] OK -
Parameter Description
parameter
Value
Instruction