80591ST10886A Rev.2 Page 95 of 200 2018-07-02
0
QCI is selected by network
1-4
Value range for 95uaranteed bit rate Traffic Flows
5-9
Value range for non-guarenteed bit rate Traffic Flows
<DL_GBR> -
A numeric parameter which indicates DL GBR in case of GBR QCI. The
value is in kbit/s. This parameter is omitted for a non-GBR QCI. (see
3GPP TS 24.301 [83])
<UL_GBR> -
A numeric parameter which indicates UL GBR in case of GBR QCI. The
value is in kbit/s. This parameter is omitted for a non-GBR QCI. (see
3GPP TS 24.301 [83])
<DL_MBR> -
A numeric parameter which indicates DL MBR in case of GBR QCI. The
value is in kbit/s. This parameter is omitted for a non-GBR QCI. (see
3GPP TS 24.301 [83])
<UL_MBR> -
A numeric parameter which indicates UL MBR in case of GBR QCI. The
value is in kbit/s. This parameter is omitted for a non-GBR QCI. (see
3GPP TS 24.301 [83])
11.3.
AT+CGCONTRDP PDP Context Read Dynamic Parameters
The ex
ecution com
m
and returns
the rele
vant inf
orm
ation <be
arer_id>,
<apn>,
<ip_addr
>, <s
ubnet_m
ask
>, <gw_addr
>, <DNS_pr
im_addr
>, <DNS_sec
_addr
>, <P
-CSCF_prim_addr>, <P-CSCF_sec_addr> and <IM_CN_Signalling_Flag> for a non secondary PDP Context established by the network with the primary
context identifier <cid>. If the context cannot be found an ERROR response is returned.
If the MT has dual stack capabilities, two lines of information are returned per <cid>. First one line with the Ipv4
parameters followed by one line with the Ipv6 parameters.
If the parameter <cid> is omitted, the relevant information for all established PDP contexts are returned.
NOTE: The dynamic part of the PDP context will only exist if established by the network.
The test command returns a list of <cid>s associated with active contexts.
Syntax
To Next Page
Loading...
Need help?
General
