Telit Wireless Solutions LN940A11 SERIES User Manual

80591ST10886A Rev.2 Page 70 of 200 2018-07-02
9.10. AT+CTZR Time Zone Reporting
This set command enables and disables the time zone change event reporting. If the reporting is enabled the
MT returns the unsolicited result code +CTZV: <tz> whenever the time zone is changed.
Read command returns the current reporting settings in the MT.
Test command returns supported <onoff>-values.
NOTE: The Time Zone reporting is not affected by the Automatic Time Zone setting command,+CTZU.
Syntax
Type
Command
Possible Return
Result
Instruction
Test Command AT+ CTZR =? +CTZR: (0-2)
OK
-
Read Command AT+ CTZR? +CTZR: 0
OK
-
Write Command AT+CTZR=<onoff> OK
Parameter Description
parameter
Value
Instruction
<onoff> 0
disable time zone change event reporting (default).
1
Enable time zone change event reporting
9.11. AT+CMEE Report Mobile Termination error
This set command disables or enables the use of result code +CME ERROR: <err> as an indication of an error
relating to the functionality of the MT. When enabled, MT related errors cause +CME ERROR: <err> final result
code instead of the regular ERROR final result code. ERROR is returned normally when error is related to
syntax, invalid parameters, or TA functionality.
Test command returns values supported as a compound value.

Telit Wireless Solutions LN940A11 SERIES Specifications

General

Brand	Telit Wireless Solutions
Model	LN940A11 SERIES
Category	Control Unit
Language	English