80591ST10886A Rev.2 Page 77 of 200 2018-07-02
10.4.
AT+CGQREQ Quality Of Service Profile (Requested)
This command allows the TE to specify a Quality of Service Profile that is used when the MT sends an
Activate PDP Context Request message to the network.
The set command specifies a profile for the context identified by the (local) context identification parameter,
<cid>. Since this is the same parameter that is used in the +CGDCONT and +CGDSCONT commands, the
+CGQREQ command is effectively an extension to these commands.
The QoS profile consists of a number of parameters, each of which may be set to a separate value. A special
form of the set command, +CGQREQ= <cid> causes the requested profile for context number <cid> to
become undefined. The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
Syntax
Test Command AT+ CGQREQ =? +CGQREQ: “IP”,(0-3),(0-4),(0-5),(0-9),(0-18,31)
+CGQREQ: “PPP”,(0-3),(0-4),(0-5),(0-9),(0-18,31)
+CGQREQ: “IPV6”,(0-3),(0-4),(0-5),(0-9),(0-18,31)
+CGQREQ: “IPV4V6”,(0-3),(0-4),(0-5),(0-9),(0-18,31)
OK
-
Read Command AT+ CGQREQ? +CGQREQ:
OK
-
Write Command AT+ CGQREQ =[<cid>
[,<precedence >
[,<delay> [,<reliability>
[,<peak> [,<mean>]]]]]]
OK -
Parameter Description
<cid> 1-24
A numeric parameter which specifies a particular PDP context definition (see
the +CGDCONT and +CGDSCONT commands).
To Next Page
Loading...
