Telit Wireless Solutions LN940A11 SERIES - ATQCCNMI New Message Indication; ATQCSIMSTAT Display the Status of SIM

80591ST10886A Rev.2 Page 126 of 200 2018-07-02
AT+CGACT=1,1
OK
AT$QCDGEN=1,1000
OK
Activated PDP context
13.9. AT$QCSIMSTAT Display the Status of SIM
AT$QCSIMSTAT is used to disable/enable the display of the status of the SIM.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT$QCSIMSTAT=? $QCSIMSTAT: (0-2)
OK
Read Command AT$QCSIMSTAT? $QCSIMSTAT: <n>,SIM INIT
COMPLETED
OK
Write Command AT$QCSIMSTAT=<n> OK
Parameter Description
parameter
Value
Instruction
<n> 0 Disables the feature
1 Enables the feature
13.10. AT$QCCNMI New Message Indication
This is a special case of [S2] CNMI. The behavior is exactly same for all the parameters except for <mt>=2
where the route configuration will be set as similar to <mt>=0; it does not change the NV-830 settings.
Syntax