Telit Wireless Solutions LN940A11 SERIES - AT+CHSN HSCSD Non-Transparent Call Configuration

80591ST10886A Rev.2 Page 44 of 200 2018-07-02
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+CRC? +CRC: <mode> list
OK
-
Read Command AT+CRC? +CRC: <mode>
OK
-
Write Command AT+CRC=<mode> OK -
Exec Command AT+CRC OK -
Parameter Description
parameter
Value
Instruction
<mode>
[0] Disable extended format
1 Enable extended format
6.9. AT+CHSN HSCSD Non-Transparent Call Configuration
This set command controls parameters for originating non-transparent HSCSD calls. Values may also be used
during mobile terminated data call setup. In GERAN, changing <topRx> or <codings> value during a call does
not affect the current call. In GERAN, changing of <wAiur> or <wRx> affects the current call only if <topRx> was
non-zero when call was established textual format
.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+CHSN=?
+CHSN: (list of supported <wAiur>s), (list of
supported
<wRx>s),(list of supported <topRx>,(list of
supported
-