Telit Wireless Solutions LN940A11 SERIES - Itu-T V.80 Ter Synchronous Data Mode Commands; AT+ES Enable Synchronous Mode

80591ST10886A Rev.2 Page 156 of 200 2018-07-02
AT$QCPRFMOD is used to configure parameters for 3GPP2/EPC profile, This command uses tag:<value>
syntax for all the parameters which allows users to specify these parameters in any order except for first
parameter. PID and various ParamName tags defined for parameters in this command. First parameter of
this command must be PID.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT$QCPDPCFGEXT=?
$QCRCIND: (list of
PID:<Value>,Param
Name:<ParamValue> )
OK
Read Command AT$QCPRFMOD?
$QCPRFMOD: PID:<Value>,Param
Name:<ParamValue>
OK
There can be 15 profile
parameters
with syntax
ParamName:<ParamValue>
Write Command AT$QCPRFMOD=PID:<V
alue>,Param
Name:<ParamValue>
OK
Parameter Description
parameter
Value
Instruction
PID:<Value> 100 to 178 range of allowed profile numbers
14. ITU-T V.80TER SYNCHRONOUS DATA
MODE COMMANDS
14.1. AT+ES Enable Synchronous Mode
AT+ES command is used to enable synchronous mode. Support in 3GPP.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+ES=? +ES: (6),,(8)