Telit Wireless Solutions LN940A11 SERIES - AT+AGC Set RF RSSI

80591ST10886A Rev.2 Page 172 of 200 2018-07-02
<oper_mode> 0 ONLINE mode
1 FTM mode
Example
AT+FTM=1
OK
AT+FTM?
Device is in: 1, FTM
OK
AT+FTM=0
OK
AT+FTM?
Device is in: 0, ONLINE
OK
15.16. AT+AGC Set RF RSSI
AT+ AGC command is used to set specified configuration of RF RSSI. Before send this command, must
be sure the device is in FTM mode.
Syntax
Type
Command
Possible Return Result
Instruction
Read Command AT+AGC? <mode>, main RSSI: <value>
Write Command AT+AGC=<tech>,<band>
,<channel>,<lna>,<path>[
,<tx_bandwidth>,<rx_ban
dwidth>]
OK
Parameter Description