Telit Wireless Solutions LN940A11 SERIES - 15.28. ATIMSTESTMODE EnableDisable IMS Test Mode

80591ST10886A Rev.2 Page 191 of 200 2018-07-02
15.28. AT^IMSTESTMODE Enable/Disable IMS Test Mode
AT^IMSTESTMODE is used to enable/disable IMS(IP Multimedia Subsystem) test mode, if IMS test mode
is enabled, IMS registration attempts will not occur and SMS is not supported.
Syntax
Type
Command
Possible Return Result
Instruction
Read Command AT^IMSTESTMODE?
^IMSTESTMODE : IMS Test Mode
Enabled /Disabled
OK
Write Command AT^IMSTESTMODE
=<mode>
^IMSTESTMODE : Enable /Disable
IMS Test Mode
OK
Parameter Description
parameter
Value
Instruction
<mode> 0 Disable
1 Enable
Example
AT^IMSTESTMODE?
^IMSTESTMODE : IMS Test Mode Enabled
OK
AT^IMSTESTMODE=0
^IMSTESTMODE : Disable IMS Test Mode
OK
AT^IMSTESTMODE?
^IMSTESTMODE : IMS Test Mode Disabled
OK