80591ST10886A Rev.2 Page 110 of 200 2018-07-02
+CDS: <fo>,<mr>,[<ra>],[<tora>],<scts>,<dt>,<st> (text
mode enabled)
<bfr> [0] modem buffer of unsolicited result codes defined within this
command is flushed to the DTE when <mode> 1 – 3 is
entered (OK response shall be given before flushing the
codes)
1
modem buffer of unsolicited result codes defined within this
command is cleared when <mode> 1 – 3 is entered
Example
AT+CPMS=”SM”,”SM”,”SM”
+CPMS: 42,50,42,50,42,50
OK
AT+CNMI=1,2
OK
+CMT: “+8618576408172”,,”16/10/10,11:21:05+32”
test cnmi
New message indications to TE
Sand a message to SIM
Receive a message and show the message content
12.9.
AT+CMGL List SMS Messages from Preferred Store
This command is used to return messages with status value <stat> from message storage <mem1> to the TE. If
the status of the message is not received unread’, the status in the storage changes to ‘received read’.
Syntax
Test Command AT+CMGL=? +CMGL: (list of supported <stat>s)
Write Command AT+CMGL[=<stat>] SMS-DELIVERs;
+CMGL:
<index>,<stat>,<o
a/da>,[<alpha>],[
To Next Page
Loading...
Need help?
General
