Telit Wireless Solutions LN940A11 SERIES - AT+DPRENABLE Set Status of DPR

80591ST10886A Rev.2 Page 165 of 200 2018-07-02
15.9. AT+DPR_ENABLE Set Status of DPR
AT+ DPR_ENABLE command is used to set the status of DPR.
Syntax
Type
Command
Possible Return Result
Instruction
Read Command AT+DPR_ENABLE?
+DPR_ENABLE: Have not set
DPR_enable, DPR is disable.
Disable
+DPR_ENABLE: Get DPR enable
State success. DPR_enable=
<mode>
Success
Write Command
AT+DPR_ENABLE=<mod
e>
+DPR_ENABLE: set DPR
enable/disable
success.DPR_enable =<mode>
OK
Parameter Description
parameter
Value
Instruction
<mode> 0 Disable
1 Enable
Example
AT+DPR_ENABLE=0
+DPR_ENABLE: set DPR disable
success.DPR_enable = 0
OK
AT+DPR_ENABLE?
+DPR_ENABLE: Get DPR state success.
DPR_enable= 0.
OK
Disable DPR