Telit Wireless Solutions LN940A11 SERIES - ITU-T V.25 TER DTE-DCE Interface Commands; ATS3 Command Line Termination

80591ST10886A Rev.2 Page 18 of 200 2018-07-02
4. ITU-T V.25TER DTE-DCE INTERFACE
COMMAND
4.1. ATS3 Command Line Termination
ATS3 determines the character recognized by the device to terminate an incoming command line. It is also
generated for result codes and information text, along with character value set via ATS4.
Syntax
Type
Command
Possible Return Result
Instruction
Read Command ATS3? <n>
OK
-
Write Command
ATS3=<n> OK -
Parameter Description
parameter
Value
Instruction
<n> 0~127 Default value is 13 (Corresponding ASCII character CR
carriage return )
Notice: if change this value, it possible to affect the
execution of the AT command.
Example
ATS3=32
OK
ATS32?
32
OK
In this point, the AT command line terminator has become a
space instead of the previous carriage return