Telit Wireless Solutions LN940A11 SERIES User Manual

80591ST10886A Rev.2 Page 94 of 200 2018-07-02
2
Enable network registration and location information unsolicited result code
11.2. AT+CGEQOS Define EPS Quality of Service
The set command allows the TE to specify the EPS Quality of Service parameters <cid>, <QCI>, [<DL_GBR>
and <UL_GBR>] and [<DL_MBR> and <UL_MBR>] for a PDP context or Traffic Flows. When in UMTS/GPRS
the MT applies a mapping function to UTMS/GPRS Quality of Service. Refer subclause 9.2 for <err> values.
A special form of the set command, +CGEQOS= <cid> causes the values for context number <cid> to become
undefined.
The read command returns the current settings for each defined QoS.
The test command returns the ranges of the supported parameters.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+ CGEQOS=? +CGEQOS: (1-24),(0-9),(0-
150000),(0-50000),(0-150000),(0-
50000)
OK
-
Read Command AT+CGEQOS? OK -
Write Command AT+CGEQOS=[<cid>[,<QCI>[,<DL_GBR>,
<UL_GBR>[,<DL_MBR>,<UL_MBR]]]]
OK -
Parameter Description
parameter
Value
Instruction
<cid> 1-24
A numeric parameter which specifies a particular EPS Traffic Flows definition
in EPS and a PDP Context definition in UMTS/GPRS (see the +CGDCONT
and +CGDSCONT commands).
<QCI>
A numeric parameter that specifies a class of EPS QoS. (see
3GPP TS 23.203 [85])

Telit Wireless Solutions LN940A11 SERIES Specifications

General

Brand	Telit Wireless Solutions
Model	LN940A11 SERIES
Category	Control Unit
Language	English