Telit Wireless Solutions LN940A11 SERIES - AT+CGDATA Enter Data State

80591ST10886A Rev.2 Page 88 of 200 2018-07-02
Read Command AT+ CGACT? +CGACT: 1,0
+CGACT: 2,0
OK
-
Write Command AT+ CGACT = [<state>[,<cid>[,<cid>[,…]]]] OK -
Parameter Description
parameter
Value
Instruction
<state>
Indicates the state of PDP context activation
0
Deactivated
1
Activated
<cid> 1-24
Specifies a particular PDP context definition (see the +CGDCONT and
+CGDSCONT commands).
10.10. AT+CGDATA Enter Data State
The execution command causes the MT to perform whatever actions are necessary to establish
communication between the TE and the network using one or more Packet Domain PDP types. This may
include performing a PS attach and one or more PDP context activations. If the <L2P> parameter value is
unacceptable to the MT, the MT shall return an ERROR or +CME ERROR response. Otherwise, the MT
issues the intermediate result code CONNECT and enters V.250 online data state.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+ CGDATA=? CGDATA: (“PPP”)
OK
-
Write Command AT+ CGDATA = [<L2P> ,[<cid> [,<cid> [,…]]]] CONNECT 150000000 -
Parameter Description