Telit Wireless Solutions LN940A11 SERIES - LTE-Specific Packet Domain Modem Compatibility Commands; AT+CEREGEPS Network Registration Status

80591ST10886A Rev.2 Page 93 of 200 2018-07-02
11. LTE-SPECIFIC PACKET DOMAIN MODEM
COMPATIBILITY COMMANDS
11.1. AT+CEREGEPS Network Registration Status
The set command controls the presentation of an unsolicited result code +CEREG: <stat> when <n>=1 and
there is a change in the MT’s EPS network registration status in E-UTRAN, or unsolicited result code
+CEREG: <stat>[,<tac>,<ci>[,<AcT>]] when <n>=2 and there is a change of the network cell in E-UTRAN.
NOTE 1: If the EPS MT in GERAN/UTRAN/E-UTRAN also supports circuit mode services and/or GPRS
services, the +CREG command and +CREG: result codes and/or the +CGREG command and +CGREG: result
codes apply to the registration status and location information for those services.
The read command returns the status of result code presentation and an integer <stat> which shows whether
the network has currently indicated the registration of the MT. Location information elements <tac>, <ci> and
<AcT> are returned only when <n>=2 and MT is registered in the network.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+ CEREG=? +CEREG: (0-2)
OK
-
Read Command AT+CEREG? +CEREG: 0,1
OK
-
Write Command AT+CEREG =[<n>] OK -
Parameter Description
parameter
Value
Instruction
<n> 0
Disable network registration unsolicited result code
1
Enable network registration unsolicited result code