Telit Wireless Solutions LN940A11 SERIES User Manual

80591ST10886A Rev.2 Page 47 of 200 2018-07-02
6.11. AT+CSTF Settings Time Format
This set command sets the time format of the time information presented to the user, which is specified by use
of the <mode> parameter. The <mode> affects the time format on the phone display and doesn’t affect the time
format of the AT command serial interface, so it is not actually used.
Read commands reads the current setting. Test command reads the supported <modes>s
.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+CSTF=? +CSTF: <mode> list
OK
-
Read Command AT+CSTF? +CSTF: <mode>
OK
-
Write Command AT+CSTF=<mode> OK -
Parameter Description
parameter
Value
Instruction
<mode>
1 HH:MM (24 hour clock)
2 HH:MM a.m./p.m.
6.12. AT+CSDF Settings Date Format
This command sets the date format via MMI of the date information presented to the user, which is specified by
use of the <mode> parameter. The <mode> affects the date format on the phone display and doesn’t affect the
date format of the AT command serial interface. The command also sets the date format of the TE-TA interface,
which is specified by use of the <auxmode> parameter (e.g. the <auxmode> affects the <time> of +CCLK). If

Telit Wireless Solutions LN940A11 SERIES Specifications

General

Brand	Telit Wireless Solutions
Model	LN940A11 SERIES
Category	Control Unit
Language	English