Telit Wireless Solutions LN940A11 SERIES - ATQCPRFMOD Configure Parameters for 3 GPP2 EPC Profile155

80591ST10886A Rev.2 Page 155 of 200 2018-07-02
Test Command AT$QCPRFCRT=? $QCPRFCRT:
OPRT1,2),TECH1,2),PERSIST
0,1),PID100,179),APNNAME:””,
PDPTYPE:””
OK
Read Command AT$QCPRFCRT?
$QCPRFCRT: PID: <Value>,TECH:
<Value>,PERSIST:
<Value>,APNNAME:”
<Value>”,PDPTYPE:” <Value>”
OK
Write Command AT$QCPRFCRT=OPRT:
<Value>,PERSIST:<Valu
e>,TECH:<Value>,PID:
<Value>,APNNAME:<Val
ue>,PDP
TYPE:<Value>
OK
Parameter Description
parameter
Value
Instruction
OPRT:<Value> 1 Create profile
2 Delete profile
TECH:<Value> 1 3GPP2
2 EPC (Not recommended)
PERSIST:<Value> 1 Non persistent
2 Persistent Mandatory in case of creation
PID:<Value> 100 to 178 range of allowed profile numbers
APNNAME:<Value> String type
PDPTYPE:<Value> String type
13.47. AT$QCPRFMOD Configure Parameters for 3GPP2/EPC Profile