Telit Wireless Solutions LN940A11 SERIES - AT+IFC DTE-Modem Local Flow Control

80591ST10886A Rev.2 Page 24 of 200 2018-07-02
<value>
Determines
the number of bits in the data bits, the presence of a parity bit, and the number of
stop bits in the start-stop frame.
[3]
8 data bit, 1 stop bit
<parity> D
etermines how the parity bit is generated and checked, if present; this sub parameter has no
meaning.
0 Odd (not supported)
1
Even (not supported)
2
Mark
[3]
None
4.11. AT+IFC DTE-Modem Local Flow Control
This set command selects the flow control behavior of the serial port in both directions: from DTE to modem
(<by_ta> option) and from modem to DTE (<by_te>).
Syntax
Type
Command
Possible Return
Result
Instruction
Test Command AT+IFC=? +IFC: =(<by_te>list),
(<by_ta>list)
OK
-
Read Command AT+IFC?
+IFC: =<by_te>,
<by_ta>
OK
-
Write Command AT+IFC=<by_te>, <by_ta> OK -
Parameter Description
parameter
Value
Instruction
< by_te >
Flow control option for the data received by DTE
0 flow control None