Telit Wireless Solutions LN940A11 SERIES - ATGTAC Get Tunable Antenna Information

80591ST10886A Rev.2 Page 167 of 200 2018-07-02
<DSI1> High power
<DSI3> Low power
Example
AT+DPR=LTE,1,28,32
+DPR: set LTE Band1: DSI1=28.0, DSI3=32.0
Note
• Need to enable the DPR by using “AT+DPR_ENABLE”.
15.11. AT$GTAC Get Tunable Antenna Information
AT$GTAC command is used to get tunable antenna information
Syntax
Type
Command
Possible Return Result
Instruction
Read Command AT$GTAC? TA(tunable antenna) information
OK
Parameter Description
parameter
Value
Instruction
NULL
Example
AT$GTAC?
Show the TA(tunable antenna) information
Band name | ANTCTL3 | ANTCTL2 | ANTCTL1 | ANTCTL0
LTE BAND:
LTE_B1: 1 | 1 | 1 | 1
LTE_B2: 1 | 1 | 1 | 1
LTE_B3: 1 | 1 | 1 | 1
LTE_B4: 1 | 1 | 1 | 1