Telit Wireless Solutions LN940A11 SERIES - AT+USBSWITCH Select USB Composition

80591ST10886A Rev.2 Page 179 of 200 2018-07-02
AT^SETMODE?
^SETMODE: 0
OK
AT^SETMODE=1
OK
AT^SETMODE?
^SETMODE:1
OK
AT^SETMODE=2
OK
AT^SETMODE?
^SETMODE:2
OK
Extension mode
Legacy mode
15.20. AT+USBSWITCH Select USB Composition
AT+USBSWITCH command is used to set the default USB composition that you want and then reboot
device. It means you can switch USB composition to normal，extension or legacy mode.
This command is same as AT^SETMODE.
Syntax
Type
Command
Possible Return Result
Instruction
Test Command AT+USBSWITCH=? + USBSWITCH: (0, 1, 2)
Write Command
AT+ USBSWITCH
=<value>
OK
Read Command AT+ USBSWITCH? + USBSWITCH: 0
+ USBSWITCH:1
+ USBSWITCH:2
Normal mode
Extension mode
Legacy mode