Telit Wireless Solutions LN940A11 SERIES - ATS10 Set Disconnect Delay after Indicating the Absence of Data Carrier; ATS8 Comma Dial Pause Time

80591ST10886A Rev.2 Page 31 of 200 2018-07-02
parameter
Value
Instruction
<value> 0-[1]-255
Number of rings, 0 is default value, the value shows clearly
time out seconds
4.22. ATS8 Comma Dial Pause Time
ATS8 is implemented for compatibility reasons only, and has no effect.
Syntax
Type
Command
Possible Return Result
Instruction
Read Command ATS8? <value>
OK
-
Write Command ATS8=[value] OK -
Parameter Description
parameter
Value
Instruction
<value> 1-[2]-255 2 is default value
4.23. ATS10 Set Disconnect Delay after Indicating the Absence of Data Carrier
ATS10 determines the amount of time, that the UE remains connected in absence of a data carrier. If the data
carrier is detected before disconnect, the UE remains connected.
Syntax
Type
Command
Possible Return Result
Instruction
Read Command ATS10? <value>
OK
-
Write Command ATS10=[value] OK -