Telit Wireless Solutions LN940A11 SERIES - AT&W Store AT Command Setting to User Defined Profile

80591ST10886A Rev.2 Page 22 of 200 2018-07-02
Parameter Description
parameter
Value
Instruction
<value> [0]
CONNECT result code returned. Dial tone and busy detection
are disabled.
1 CONNECT <text> result code returned. Dial tone and busy
detection are disabled.
2
CONNECT <text> result code returned. Dial tone detection is
enabled, busy detection is disabled.
3 CONNECT <text> result code returned. Dial tone detection is
disabled, busy detection is enabled.
4 CONNECT <text> result code returned. Dial tone and busy
detection are both enabled.
4.8. AT&W Store AT Command Setting to User Defined Profile
AT&W stores the current AT command settings to a user defined profile in non-volatile memory of device. The
AT command settings will automatically be restored from the user defined profile during power-up or if ATZ is
used. AT&F restores AT command factory default settings. Hence, until first use of AT&W, ATZ works as
AT&F.
Syntax
Type
Command
Possible Return Result
Instruction
Exec Command AT&W[<value>] OK -
Parameter Description
parameter
Value
Instruction
<value> [0] User Profile Number
4.9. AT&E Store AT Command Setting to User Defined Profile
Controls the display of data rate to be either serial rate or wireless connection speed.